PTFE TUBE AND SHELL HEAT EXCHANGER, WE HAVE MAINLY TWO TYPES: COIL TYPE AND STRAIGHT TUBE TYPE.

1. COIL TYPE, DIAMETER IS USUALLY 10/8MM, 6/5MM AND 3/2MM. ONE WHOLE TUBE (COIL) CAN BE AS LONG AS 150 METERS.

PRESSURE AS 1.0 Mpa MIN,

TEMPERATURE IS AS HIGH AS 220 OR 250 C, AS LOW AS -50C.

SPEC.: 2 - 200 M2 or AS PER USER'S REQUEST.

2. STRAIGHT TUBE TYPE: DIAMETER IS USUALLY 30-40 MM.  LENGTH 2000-6 000MM.

PRESSURE: 10 BAR MIN,

TEMPERATURE IS AS HIGH AS 220 OR 250 C, AS LOW AS -50C.

SPEC.: 2 - 200 M2 or AS PER USER'S REQUEST.

CHARACTER FOR PTFE EXCHANGER:

3. CHARACTER: IT HAS VERY LONG USING TIME; IT CAN FIT FOR ANY SOLUTION IN ANY %. NO IMPURITY UNDER USING - MEANS THE INNER DIAMETER OF THE TUBES WILL NOT BECOME SMALLER AFTER LONG TIME OF USE; SMALLER WEIGHT AND BULKK; STRONG ENOUGH TO AVOID ANY DAMAGES; EASY FOR TRANSPORT.

4. KKIND NOTE: FOR THE ABOVE TWO TYPES, WE RECOMMEND THE FIRST COIL (PIPE) TYPE. BY THIS TYPE, THE LENGTH OF THE TUBE CAN BE VERY LONG, THE THICKKNESS AND DIAMETER OF THE TUBE CAN BE VERY VERY SMALL. SMALLER THICKKNESS MEANS MUCH BETTER THERMAL CONDUCTIVITY. IT CAN EVEN GIVE BETTER THERMAL CONDUCTIVITY THAN THE GRAPHITE HEAT EXCHANGER! AT THE SAME TIME, SINCE THE DIAMETER OF THE TUBE IS ALSO VERY SMALL, THE PRESSURE CAN ALSO BE VERY BIG. AND, SINCE THE LENGTH OF THE TUBE CAN BE VERY VERY LONG, THE AVAILABLE SURFACE CAN ALSO BE VERY BIG. THAT IS TO SAY, THE SMALLEST THICKKNESS GIVE THE BEST CONDUCTIVITY, THE SMALLEST DIAMETER GIVE THE BEST PRESSURE, THE LONGEST LENGTH GIVE THE BEST SURFACE. AND AT THE SAME TIME IT ALSO HAVE THE ADVANTAGES AS MENTIONED ABOVE.

OUR SUGGESTION IS: PLEASE ONLY TELL US OF YOUR REQUEST, WE CAN DESIGN A SUITABLE TYPE OF EQUIPMENT FOR YOU. AND WE ARE SURE YOU WILL HAVE TO BE SATISFIED.